Multiquip LS600P Water Pump User Manual


 

Figure 5 and illustrates the location of the major
components for the LS600P Concrete Pump. The function
of each component is described below:
1. Tow Hitch Coupler — Requires a 2-inch ball hitch or
a 3-inch pintle. Capable of towing 8,000 lbs.
2. Radio Control Antenna Mounting location for radio
control antenna. Works in conjunction with hand-held
radio remote (option).
3.  Release latch and lift door
to access the hydraulic manifold block.
4. Hydraulic Oil Reservoir Access Cover Remove
this cover to gain access to the hydraulic oil tank for
maintenance/cleaning.
5.  Manifold block
that controls the flow of hydraulic pressure to the
components required to control the pump.
6.  Under pressure, the
shuttle cylinder shears concrete passing from the
concrete cylinder to the delivery line during the cycle
phase. ALWAYS keep hands clear from shuttle cylinder
during operation.
7. Rear Pumping Jack Stand Use this jack stand
to level and support the rear end of the pump during
operation.  deploy on un-level ground and
always check for firmness of ground.
8. Tires — This trailer uses two ST235/80R16 type tires.
Tire inflation pressure is the most important factor in
tire life. Pressure should be checked to 80 psi cold
before operation. DO NOT bleed air from tires when
they are hot. Check inflation pressure weekly during
use to insure the maximum tire life and tread wear.
9.  Fill with diesel fuel. Fuel tank (cell)
holds approximately 40 gallons (176 liters). DO NOT
top off fuel. Wipe up any spilled fuel immediately.
10. Battery This unit uses a +12 VDC type battery.
ALWAYS use gloves and eye protection when handling
the battery.
11.  Remove this cover
to gain access to the fuel tank for maintenance/cleaning.
12. Parking Jack Stand Use this jack stand to level
and support the tow end of the pump.
13. Front Pumping Jack Stand Use this jack stand
to level and support the rear end of the pump during
operation.  deploy on un-level ground and
always check for firmness of ground.
14.  This pump uses 5/16-inch thick,
72 inches long zinc-plated saftey chains. ALWAYS
connect safety chains when towing.
PUMP COMPONENTS