Filter
Top Products
10. It is important that once the slurry procedure is
completed, and concrete is flowing through the hose,
DO NOT stop the pour until all the slurry is pumped
out and the concrete has reached the end of the hose.
The only time to stop the pump during the priming
procedure is if a blockage occurs.
11. If it is necessary to replace or add a section of delivery
system, after the initial lubrication procedure, wet the
inside area of the hose, pipe or elbow with 5 gallons of
water per 25 foot length, before adding it to the system.
The LS600P Concrete Pump has a remote control feature
that allows the pump to be remotely controlled. If desired,
the pump can be operated via a receiver/transmitter (radio)
or a hardwire method, which utilizes a 25-ft. extension cable.
Contact MQ Sales Department to order remote control.
Radio Remote Control
Installation of the Radio Remote Control Assembly
1. Remove the two screws (Figure 34) on the digital
control panel that secure the front panel to the control
box.
Figure 34. Removing The Control Box
NOTICE
When pumping long distance or pumping stiff mixes, you
can expect a drop in volume compared to shorter lines
and wetter mixes due to the change in valve efficiency
or cavitation.
E
M
E
R
G
E
N
C
Y
S
T
O
P
OFF
ON
IGNITION
REMOTE
CONTROL
FLOW
DIRECTION
VOLUME
LOCAL
FOR
WARD
AUT
OMA
TIC
JOG
RESET
SET
DECREASE
INCREASE
SCROLL
JOG
“A”
CYLINDER STROKE
JOG
“B”
REVERSE
CENTER
OFF
REMOTE
START
REMOVE 2 SCREWS
CONTROLB
OX
2. Tilt and slowly pull out the control panel and place on
top (Figure 35) of control box to gain access inside
the box.
Figure 35. Pulling Out Control Panel
3. Install the wireless remote module (Figure 36) with the
2 screws and nuts provided inside the control panel.
Connect the 3-wire connector from the wireless remote
module to the electronic control unit.
Figure 36. Installing Remote Control Module
FRONT P
ANEL
ELECTRONIC
CONTROL
UNIT
SCREWS
AND NUTS
WIRELESS
REMOT
E
MODULE
CONNECTOR
ELECTRONIC
CONTROL
UNIT
OPERATION