Filter
Top Products
74D3000
4
BLDV7 Series Gas Fireplace
Figure 54 -
Rock wool placement
1. Place rock wool on burner to provide glowing
embers. For best results, pull the rock wool apart
into pieces the size of a dime or smaller.
. Distribute one layer of rock wool to cover the burner.
Figure 53
3. Place the logs on the burner. Refer to Log Placement
below. Light unit and after 15 minutes, check burner
flame and glow. Refer to Burner Flame, Page 44.
If the flame is blue and only in the center, turn off unit
and let cool. After unit cools, remove logs. If the back
holes are clear, add more rock wool to the center of the
burner. Replace logs and check flame again. Save left
over rock wool to refresh when cleaning later. Too much
rock wool can disturb the flame and cause sooting on
the glass or logs.
1. Place the rear log (#1) in place by sliding it over the
rear pins on the right and the left.
. Place the right front log (#3) over the burner and grate
by matching the hole on the bottom of the log with
the pin on the burner. Also match the cut-out on the
bottom of the log with the bars on the grate.
When this log is in place pull towards the front.
3. Place the left front log (#5) over the burner and grate
by matching the holes on the bottom of the log with
the pin on the burner. Also match the cut-out on the
bottom of the log with bars on the grate. When
this log is in place the branch on this log will lay over
the rear log on the left. Pull log forward.
4. Place the right upper log (#) at an angle toward
the burner by matching the rectangular notch on the
bottom of this log with the rectangular protrusion on
the right front log (#3). The burned side of this log will
point toward the burner.
Place the hearth brick centered in front of burner and slide back until it hits the stops on the right
and left of burner.
FP2340
BDVL base
Figure 53 -
Placement of Rock Wool on Burner
Cover with
Rock Wool
Burner
FP340
LG648
BLDV ember place
LG648