Filter
Top Products
6G7 ENGINE (E-W) -
Crankshaft, Flywheel and Drive Plate
11A-13-4
INSTALLATION SERVICE POINTS
"
A
A
CRANKSHAFT BEARING
When bearing replacement is required, select and install the
correct bearing by the following procedure.
(1) Measure t he crankshaft journal diameter and confirm its
classification from the following table. In the case of a
crankshaft supplied as a service part, identification
colours/marks of its journals are painted/stamped at the
positions shown in the illustration.
(2) The cylinder block bearing bore diameter identification
marks are stamped at the position shown in the illustration
from left to right, beginning at No. 1.
Combination of crankshaft journal diameter and cylinder block bearing bore diameter Bearing
Crankshaft journal Cylinder block
identification
colour or
Classification Identification colour O.D. mm
bearing bore
diameter
identification
mark (for service
Production part Service part
identification
mark
part)
1 None Yellow , 0 59.994 - 60.000 I Pink, 1
II Red, 2
III Green, 3
2 None None, 1 59.988 - 59.994 I Red, 2
II Green, 3
III Black, 4
3 None White, 2 59.982 - 59.988 I Green, 3
II Black, 4
III Brown, 5
PWEE9615
E
Dec. 1996Mitsubishi Motors Corporation
7EN0991
Identification colour position
No. 3
journal
No. 2
journal
No. 1
journal
No. 4
journal
7EN0992
No. 4
No. 3
No. 1
No. 2
Timing belt side
Cylinder bore size mark
Cylinder block bearing
bore identification mark