Filter
Top Products
6G7 ENGINE (E-W) -
Rocker Arms and Camshaft
11A-9-3
INSTALLATION SERVICE POINTS
"
A
A
CAMSHAFT
(1) Before attaching the camshafts, apply engine oil to the
journals and cams.
Take care not to confuse the right bank a n d left bank
camshafts.
NOTE
The right bank camshaft has 4-mm-wide slits in the rear
end surface.
(2) Make surethe camshaft dowel pin is at the location shown.
"
B
A
LASH ADJUSTER
(1) Immerse the lash adjuster in clean diesel fuel No. 2.
(2) While pushing down the inside steel ball with the special
air bleeding wire tool, move the plunger up and down
four or five times to evacuate air from the lash adjuster.
(3) Taking care not to spill the diesel fuel, install the lash
adjuster into the rocker arm and attach a special tool to
prevent it from falling out.
"
C
A
ROCKER ARM SHAFT
(1) The end with the larger chamfer is at the right on the
front bank and at the left on the rear bank.
NOTE
The side with the four bolt holes is on the intake side.
(2) The side with the oil holes is on the lower side (cylinder
head side).
PWEE9615
E
Dec. 1996Mitsubishi Motors Corporation
7EN0708
Slot
7EN0709
Right bank Left bank
Approx
60
_
Approx
71
_
7EN0721
MD998442
7EN0722
MD998443
Lash adjuster
9EN0511
Timing belt side
Chamfered
Oil hole