Filter
Top Products
9
ARMING AND LEAVING WITH OTHERS STAYING
1
Check the Touchpad indicators. The green STATUS light must be ON-STEADY, and the LCD dis-
play will read "SYSTEM READY", indicating that the system is ready to arm.
• If t he green STATUS light is off and zone s are scrollin g in the display, a perimeter zone is fau lted or a moni-
tored deadbolt (other than your exit door) is unlocked. Check the open zones listed and close the door,
window, or lock the deadbolts as needed. If you cannot immediately secure the zones or lock the dead-
bolts, the y may be bypasse d (see page 7).
2
Press the STAY button.
The Touchpad will voice prompt the correct action.
•
If you change your mind after pressing AWAY, press RESET to clear arming.
3
Open the garage door and exit. (Note: See page 13 if your garag e door motor fails).
4
Close the garage door from the outside to arm the system (with your existing garage door opener
remote control).
If the garage door has not been closed within the exit delay time period (usually within 3
minutes of pressing STAY, but this tim e period can be changed by your installer), the sys-
tem will revert back to a disarmed state.
If you are arming and leaving with other family members remaining home:
The red ARMED light will turn on steady, indicating the 3 minute exit delay period.
STAY
SYSTEM READY
ARMED
"The system is arm-
ing in Stay mode"
F-64TPG_OI320A.03_USER_2...
page 9
Friday, September 15, 2006 11:40
Composite