Filter
Top Products
8
ARMING STAY: PROTECTING YOURSELF AT HOME
Arming in the Stay mode allows you to remain home with the perimeter protection active but with the interior protection off,
so that you may move freely within the premises. Arm Stay at the Gara ge Touchpad as follows:
1
Check the Touchpad indicators. The green STATUS light must be ON-STEADY, and the LCD dis-
play will read "SYSTEM READY", indicating that the system is ready to arm.
• If the green STATUS light is off and zones are scrolling in the display, a perimeter zone is faulted or a moni-
tored deadbolt (other than your exit door) is unlocked. Check the open zones listed and close the door,
window, or lock the dea dbolts as needed. If you cannot immediat ely secure the zones or lock the deadbol ts,
they may be bypassed (see page 7).
2
Press the STAY button.
The Touchpad will voice prompt the correct action.
•
If you change your mind after pressing AWAY, press RESET to clear arming.
3
If the garage door is already closed, the ARMED indicator will light and the LCD display will read
"ARMING STAY". The system w ill arm in the Stay mode within 3 minutes.
4
If the garage door is NOT closed, close the garage door from the inside to arm the system.
If the garage door has not been closed withi n the exit delay time period (usually within 3 min-
utes of pressing STAY, but this time period can be changed by your installer), the system will
revert back to a disarmed state. (Note: See page 13 if your garage door motor fails).
SYSTEM READY
STAY
ARMED
"The system is arm-
ing in Stay mode"
F-64TPG_OI320A.03_USER_2...
page 8
Friday, September 15, 2006 11:40
Composite