Filter
Top Products
28
DVB4136 Direct Vent Gas Fireplace
20012322
5. Place the top front log. Set
the log by matching the
square hole on the bottom
with the square emboss
on the left log. Lay the log
at an angle to the left over
the fettle. When this log is in place,
it must not cover the hole in the left
log. (Fig. 53)
6. Place the top center log. Hold the
log with the pointed end toward
the back. Match the two holes on
the bottom of the log with the two
pins on the top of the front log.
(Refer to Figure 52 for pin loca-
tions) Set the log and lay it into
the rear log. (Fig. 53)
7. Place the top right log. Hold the
log with pointed end to the left.
Match the two holes on the bot-
tom of the log with the two pins
on the rear log and set the fork on the log over the
right front log. (Fig. 53)
8. Place the lava rock on the hearth refractory in the
front as desired. (Fig. 53)
Rear
Log
Top Center Log
Top Right Log
Front
Log
Top Front Log
Lava Rock
LG464
Figure 53