Filter
Top Products
_ FRONT INSTALLATION
Instali the front grille(packed separately) onto. f_e
cabinet as follows:
• Hook upper tabs offront grille intoslots on the
cabins top_ (FIG, 19}
= Push front gdlWs tips towards the cabinet in order
to snap side tabs intothe cabinet. {FIG. 19)
, Open the inlet grille. (FIG. 20)
, Install the ecr_t_ (ITEM E) through the front gri|te.
(FIG, 20>
- Close inletgrille. (FIG. 2i}
Front tnetatlatlo_
RG. 19
tl'£M -?_.
FrontInstallation
FIG, 20
Front installation
FIG. 21
_IF AIR CONDITIONER IS BLOCKED ;BY
STORM WINDOW FP,_ME
• tf storm windowpresentsinterference,f_sten a 2"
widewoodstriptotheinnerwindowsillacrossthefull
widthofthesill Thewoodstripshouldbe thick
enoughtoraise the heightof the windowsiil so that
the unit can beinstalledwithoutinterferencefrom the
thestormwindowframe.See FtG.P2.
Top ofwood stripshould be approximately 3/4"
higher than the storm wir_ow frame to help
condensation to drain properly tothe outside,
, Install a secondwood strip (approximately 6° long by
1V2_wide and same thickness as first strip)in the
center ofthe outer sill_h against the back ofthe
inner sill Screw the L brackets intothis strip.
This will raise the L bracket as shown in FIG. 22.
11F,#mlr_.
WOODSTRIPMOUNTED {38mm_
ON TOP OF INNE-3'_SILL _ _ E3_,__,_
"I" I / #_"'_ WINDOW
_NNER ILBRACKET/ L FRAME
k I
J"=_l I ou_mE
FIG. 22
REMOVAL FROM WINDOW
•Turn offand unplug the airconditioner.
• Removethe front _Iie_ See HOW TO REMOVE THE
FROI'_ GF_ILLE,Refer to page t3,
• Unscrew thesidescrewsthatyou installedinSt_,,p15.
•Slide the air conditione_outof_e cabinet.
BE CAREFUL NOT TO DROP iT,Hold onto it _im_Iythe
_,vholewayslidingitou_:.Once removed, set it safetyout
of theway,
• Remove the Lbracket from windowframe and the sash
sealfrom betweenthewir_Iows.
- Unscrew thes,idecurtains from thewindowframe. Fold
thsm back to the s_es of thecabinet.
, Remove screws attaching cabinetto inner sill Be carefuI
not tolet cabinet fall once screws ate remo_,
• Removecabinet from window opening.
• Pieceair conditioner intocabinet.Reinsta]_sidescrews
and FrontGrilie.
, Placeunit _nd allassembly hardware in airconditioner
s_ipping carton, and storein ck_an,dr/piece.
, Air conditionerscovered in this m_nua_pose_n
excessiveweight hazard.Two or more people
are neededto moveand instal/theunit,
To preventinjury orstrain,use proper filling and
caring techniqueswhenmoving unit,
=Whenhandling the air conditioner, be carefu_to
avoid cutsf_omsharp metal fins on front and
rear colts,
• Make sure air conditioner does not _il during
removal.
-8-