Filter
Top Products
OBSERVE ALL LOCAL CODES AND
ORDINANCES.
DO NOT, UNDER ANY CIRCUMSTANCES,
REMOVE TH_ POWER SUPPLY CORD
GROUND PRONG.
ELECTRICAL GROUND iS REQUIRED ON
THiS APPLIANCE.
k 250-volt 60 Hz, kC onty, 20A fused and
properly grounded e_ectrica_ supply is required.
A time detay fuse or time deiay circuit breaker
is recommended. Use a dedicated circuit,
serving only this appliance.
DO NOT USE AN EXTENSION CORD.
RECOMMENDED GROUNDING METHOD
For your personal safety, this appliance must
be grounded. This appliance has a power
supply cord with a 3-prong grounding plug, To
minimize possible shock hazard, the cord must
be plugged into a mating grounding type wall
receptacle and grounded in accordance with
the National Electrical Code (ANSI/NFPA 70)
latest edition and all loca!codes and
ordinances, if a mating wail receptacle is not
available, it is the personal responsibility and
obligation of the customer to have a property
grounded 3-prong wall receptacle installed by a
qualified electrician.
115V~
2aOV~
Powercordmayinc|udea currentinterrupter
dev*_.._.A testand reset buttot_is providedon the
plug_, The device shouldb_ tested ona
ped_dicbasis by f_rstpressing _heTEST butt_m
and_en the RESET"b_tton.Ifthe TEST button
does nott_ipor ifMe RESET buttonwillnotstay
engaged, discontinue use ofthe aircondIlionerand
contact0qu0#fied service techn_cien.
NOTE: The shape maybe d;fferentaccording _eitsmodel
Use Wail Receptacle Power Supply
_I ,_ 5_andardt25V,
3-_re grouttdtng
receptaclerated
15A, 125VAC UseJ5AMP,_me
.................. de_y fLIse Or_5AMP,
Standard 250V, ,circuitbreaker.
a-w_m grounding
Ie_pt_t_ r_d
15A,?_50VAC
St_r_ord25or.
3-w_regrounding
_cept_c_on_ted
2:0_.._OV AC
Use;20AMP.t_e
de_ay_uBeor20AMP.
Electr|ca_ Shock Haza_
Plugintoa grounded 3 prong outlet.
Do notremove ground prong,
De notuse an adapter.
Do not use an extension cord,
Failure to f_low these inStruclJone can result tn
death fire or aieetdca_ shock
You canchoose between two methods below according toyour windowstool shape and preference.
USING SLIT "A"
Fastenthe stopperusing I screwholes,and tead
out the power cordthroughslit "A",
USING SLIT "B"
Fastenthe stopper using leftscrewhole, and rotate
prc_perfyto lead the power cordoutthrough slit"B".