Filter
Top Products
INSTALLATION REQUIREMENTS
Yoursir conditionerwillirrstalintostandarddoublehung
w_ndowswith_ctuatclearopeningwidthsof23to38inches
(584mmto914mm)(FIG,1),
Lowersashmust open sufficientlyto allow a e_eer
vertical opening of t_5inches(381mm), Side louvers
and the rear ofthe alr conditionermust have clear
air spacetoallow enoughairflow throughthe
condenserfor heatremoval.The rear of the unit
must beoutdoors,not insideabuilding or garage,
I I /_-- Sash
,_ Exterior
lnlet_orw_1%J ..... ," RG, t
ELECTRICAL SERVICE
Check your availableelectrical service. Thepower
st@plyavalabte must bethe same as thatshown
on the unit nameplate (foundon dghtsideof Pab_net).
All models are equipped with a 3-prong service plug
to provide proper service and safe positive
grounding. Do not change plug inany w_y. Do not
use an adapter plug, if your present wal outlet does
not match your plug, c81 a qualfied electrician to
make the necessart correc4_ons,
SAVE CARTON and this OWNER'S MANUAL for
future reference. The Patton Is the best way to store
unit during wfnter or when not in use.
Toavoid riskof personal injury,property damage,
or product damage duetothe weightofthis
device and sharpedgesthat may be exposed:
• Air conditioners coveredin thismanual posean
excessive weighthazard. Two or more peopfe
are needed tomove andinstall the unit
To prevent injuryor strain, use proper lifting and
car_ing techniques whenmoving unit
. Carefu|ly inspect iocalonwhere air conditioner
willbe instaled. Be sure tt willsupport the
weightof the unt over an extended period of
time,
- Handle air conditioner withcare,Wear
protective gloves wheneverliftingor carryingthe
unit. AVOID thesharp motetfins of front and
rear coils.
, Make sure air conditioner does not fall during
installation.
INSTALLATION HARDWARE
NAME OF PARTS
A SIDE CURTAIN
B SILL SUPPORT
C BOLT
D LOCK NUT
E
F
G
H
I
J
2
2
2
2
SCREW: 25164" 13
SCREW: 5/8" 3
SCREW: 5/8" 5
FOAM STRIP 1
-- FOAM SEAL i......................
L BRACKET t 1
REQUIRED TOOLS:
=Tight Filing gloves
,' Standard screwdrive_
- Phillips screwdriver
, Pliers
- Sharp knife
• 3tSAnch open end wrench or adjustable wrench
. lt4-inch he× socket and ratchet
Tape measure
- Bectric drill
• ll4-mch drill bit
-5-