Filter
Top Products
FEATURES
1 15 6 5 4 32714
F_G. 24,
1. Cabinet
2. Vertical Air
Direction Louvers
3. Horizontal Air
Direction Louvers
4. thtef Grille
5. Air FHter
6. Front Gdlle
7. Control Panel
8, Power Cord
9. EvaporatorCoiI
10, Condenser
11. Compressor
'_2.5ass pan
_3, Brace
"_4.Upper Guide
I5. Curtain
16, Remote Control
USING THE AIR CONDITIONER
To r_duce the r_k of fire, elec_c
shock, or injury to persons, read the important
SAFETY instructions sectionbefore operating this
applianos
To begin operating the air condltlorterafter
installation, foJ!ow these steps:
t. Plug in the air conditioner. (To prevent eiectrica_
hazards, do not use an extension cord or an
adapter piucj.)
2. Set the exhaust vent to the CLOSE position.
3. Set the TEMP Control to the coolest setting.
4. Set the MODE con+rot at the highest COOL level.
5. Adjust the louvers for comfortable air flow.
6. Once the room has cooled, adjust the TEMP and
Mode Control to the setting you find most
comfortable.
NOTE : If the air conditioner isturned off, wait 3
minutes before resta_ng. This attows prassurs
|r_6e the compressor to equalize. Failure to wait 3
minutes before restarting may cause inefficient
operation.
if you move the TEMP Control to a warmer, then
fmmediate_y back to a cooler setting, the unit will
shut off. WaN 3 minutes before restarting.
VENT CONTROL
The Vent Control aitows the air cottdltioner to
either r_c_rcuiz_e inside air (CLOSE) or exhaust
air to the outside (OPEN), (F_G, 25)
- The CLOSE position Ssused when maximum
coo|ing is desired, tt may also be us_d for a_r
recirculetton without cooling when the air
conditioner is set in the FAN position.
* The OPEN position removes sta_e air from the
room and exhausts itto the outside. Fresh air is
dr_wn into the room through your home's
norrna_ air passages.
* The OPEN or CLOSE position can be used with
any mode setsc_Jon.
PULL OPEN / PUSH CLOSE
FIG. 25
-_0-