Filter
Top Products
Adjustment of Cutting Width
When cutting width is too narrow or too wide against
seam width, adjust it as follows.
1. Turn off the power switch and unplug the
machine.
2. Open the looper cover and side cover.
3. Set the upper knife to down position
4. Turn the cutting width adjusting dial to get
desired position of lower knife.
(_ Cutting width adjusting dial
Lower knife
(_ Standard setting ....
* The cutting width of this mod
approximately 3.0 to 5.0 mr..................................................................................
needle position depending :_ your sewin_ :
needs or the fabric ......being ....
(The cutting to g .............
same
When cuttin_:wiath is too na_ro ......
Turn cutting i : Iockwise (A).
Lowerknife iii : : to
When cutting width is too wide.
Turn the cutting width adjusting dial counterclockwise
(a).
Lower knife will move to left.
5. Set the upper knife to up position.
6. Close the looper cover and side cover.
L
/./
/JJ(_
//
J
20