Filter
Top Products
Changing Needle
Turn off the power switch and unplug the machine.
Raise the needle to its highest position.
Then loosen the left or right needle clamp screw for the
needle you are going to remove.
(_ Needle clamp screw on the left
(_ Needle clamp screw on the right
* Use HA-1SP#14 Needle or #11.
To attach the needle on the right "
Insert a new needle into the needle clamp with the
flat side to the back until the top of the needle
touches the stopper pin, then tighten the needle
clamp screw on the right.
To attach the needle on the left "
Insert a new needle into the needle
flat side to the back until the to_
touches the edge of the needle _ _:_ i{_ h#
needle clamp screw on the left: .......
* When the needles are set _ t!Y, the left
needle is high_[_he rig_ _:.......
* Use HA-1S_ I'4 _i_or
(]_)Needl_ i p .......
(_) Needle
(_ Needle _ _pin ....
@ Edge of ......
(_ Needle ......
(_ Flat side to the back
* Do not use any needle which is bent or blunt.
Raising or Lowering the Presser Foot
By raising or lowering the presser foot lifter, the
presser foot goes up or down.
* While in operation, keep the presser foot lowered
except when threading the machine or test running
without threads.
Thread tension will be released when the presser
foot lifter is raised.
(_ Presser foot
(_ Presser foot lifter
12
//
J