Filter
Top Products
Extension Table
• Detaching the table
Pull the table away from the machine, as illustrated, for
"free-arm" sewing of cuffs and sleeves.
• Attaching the table
Push the extension table until it snaps into the machine.
(_) Extension table
(_) Pin
(_ Holes
@ Tab
(_) Free-arm
Changing Needle
(_ Needle clamp screw
(_) Needle clamp
[_Turn off the power switch.
Raise the needle to its highest position by turning the
handwheel counterclockwise, toward you. and lowering
the presser foot. Loosen the needle clamp screw_by
turning it counterclockwise. Remove the needle from the
needle clamp (_).
[] insert a new needle nto the needle clamp@with the
flat side to the rear. When inserting the needle into the
needle clamp (_), push it up as far as it goes. Tighten
the needle clamp screw 1_ firmly by turning it clockwise.
[] To see if the needle is good, place the fiat side of the
needle onto something flat (e.g needle plate or glass).
The gap between the needle and the flat surface should
be consistent. Never use a bent or blunt needle.
A damaged needle can cause permanent snags or runs
in knits, fine silks and silk-like fabrics.
To Remove and Attach the Foot Holder
_i_ Thumb screw
_2_Foot holder
_3_Presser bar
• To remove
Remove the thumb screw _1_by turning it counterclock-
wise with a screwdriver.
• To attach
Match the hole in the foot holder _2_with the threaded
hole in the presser bar _3_. Fit the thumb screw _i_ into
the hole. Tighten the screw _1_by turning it clockwise with
screwdriver.
\
f
I
/
=lat side
_ado Diane Needle
',4eclat Aguja
Aiguille
f
J
J
10