Filter
Top Products
Bobbin Winding
• Removing bobbin case
Remove the extension table from the machine by pulling
it to the left. Open the shuttle cover O_'by pulling down
the embossed part on the left of the cover.
Raise the needle to its highest position by rotating the
handwheel toward you.
_1_ Shuttle cover
_2_ Bobbin case
To remove the bobbin case _2_from the shuttle, pull open
the latch of the bobbin case. Pull the bobbin case straight
out of the shuttle.
J
,\ _J
• Bobbin winding
[] Release the clutch by pulling out the handwheel. This
will stop the needle from moving while you wind the
bobbin.
\. j
f .....................................................................................................................................................................................................................................................................................................................................................
[]
[] Draw thread from the spool.
[] Guide the thread around the thread guide.
[] Thread through the hole in the bobbin from the inside to
the outside.
[] Put the bobbin on the bobbin winder spindle.
f
[] =4i
[]
20