Filter
Top Products
Operating Instructions (cont'd)
_[,_WARNING:lfyoudonotfollowtheseinstructionsexactiy, afireor_
explosion may result causing property damage, personal injury or
loss of life.
BEFORE OPERATING: ENTIRE SYSTEM MUST BE FILLEDWITH WATERAND AIR PURGED FROMALL LINES.
A. This appliance does not have a pilot. It is equipped • If you cannot reach your gas supplier, call the fire
with an ignition device which automatically lights the
burner. Do NOT try to light the burner by hand.
B. BEFORE OPERATING smell all around the
appliance area for gas. Be sure to smell next to the
floor because some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electric switch;
do not use any phone inyour building.
Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
department.
C. Use only your hand to push in the gas control but-
tons. Never use tools. If the control buttons will not
push in, don't try to repair them, call a qualified ser-
vice technician. Force or attempted repair may
result in a fireor explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and to replace
any part of the control system and any gas control
which has been under water.
.......7 • A IJ Ovem
WARUO O O O O O ,O
......e e ......
i i
1. I_STOP! Read the safety information above
_,#'on this label.
2. Set the ON/OFF switch on the control box to the "ON"
position.
3. Set the thermostat to_e lowest setting b_rst press-
ing the COOLER _ and HOTTER _ buttons
together and holdi.J_ for 1 second. Then press the
COOLER button £_) until the WARM indicator light
appears.
4. Set the ON/OFF switch on the control box to the
"OFF" position.
5. This appliance is equipped with a device which auto-
matically lights the burner.
DO NOT TRY TO UGHT THE BURNER BY HAND.
6. Wait five (5) minutes to if_ clear out any gas.
If you then smell gas, _ STOP! Follow "B" in
the safety information above on this label. If you
don't smell gas, go to the next step.
7. Turn on all electrical power to the appliance.
8. Set the ON/OFF switch on the control box to the
"ON" position.
9. Set the thermo_t to desired setl_ by first pressing
the COOLER k_)and HOTTER t,_,' buttons together
and hol_g for 1 second. Then press the HOTTER
button _.
10. WATER TEMPERATURE ADJUSTMENT • is
approximately 120°E
_ CAUTION: Hotter water increases the risk
of scald injury. Consult the instruction
manual before changing temperature.
11, if the appliance will not operate, follow the instruc-
tions "TO TURN OFF GAS TO APPLIANCE" and
call your technician or gas supplier.
,_ WARNING: TURN OFF ALL ELECTRICPOWER BEFORE SERVICING
1.
Set thermostat,_to the lowest settin_ by first pressing
the COOLER _ and HOTTER _ buttons together
and holding for 1 second. Then press the COOLER
button (_ until the WARM indicator light appears.
2. Set the ON/OFF switch on the control box to the
"OFF" position.
3. Turn off all electric power to the appliance if service
is to be performed.
28