Filter
Top Products
Installation Instructions (cont'd)
APPROXIMATE SETTING TIME FOR 2"TO 3" PIPE
JOINTS
MOVEMENT COMPLETE
OF JOINT SET
90°F to 150°F % hr. 8 hrs.
50°F to 90°F I hr. 15 hrs.
0°F to 50°F 1% hr. 18 hrs.
CUTTING OPENING THROUGH AN OUTSIDE
WALL AND COLLAR INSTALLATION
After reading the manual and you have determined the location
of the op,eningin the wall, (using the draw!ng below), cut a 2_"
hole for 2 vent piping or a 3_' hole for 3 vent piping through
an exterior wall.
NOTE: When determining location of the opening in the
outside wall allow for the ¼° rise per five feet that has taken
place in the horizontal run.
" '" "" I N PER FIVE FEET
L
40 GAL.- 59½"
50 GAL.- 6(7'
N
INSTALLATION SHOWING USE OF PVC, ABS OR
CPVC PIPE
SILICONE
SEALER
_. EXTERIOR
_// _"_ WALL
HIN EXTENSION
...... THROUG H
J_ _ EXTERIOR WALL
_/ _ SCREW
VENT CAP MUST
SEALER _ BE POSITIONIED
/
DOWNWARD
CONNECTING PVC, ABS OR CPVC PIPE VENT TO
BLOWER
1. If making an immediate horizontal run of vent off'the blower,
a Y' PVC, ABS or CPVC Schedule 40 (supplied locally) elbow
is required. Place the elbow in the required direction on the
blower and using 3 sheet metal screws, attach the elbow.
SEALWITH _ _ _"_"
I
2. If there is to be a vertical run of vent from the blower, the Y'
PVC, ABS or CPVC pipe must be attached to the blower using
3 sheet metal screws.
The 3" (or optional 2") PVC, ABS, or CPVC Schedule 40 vent
pipe can be run from the water heater through the wall or from
the wall to the water heater, whichever is most convenient. The
vent pipe must extend a minimum of 1_" through the exterior
wall. Extending the vent cap as far as possible from the surface
of the exterior wall will help minimize discoloration of the wall
in this area which may be caused by the flue gases. Note that the
inside collar must be slipped over the vent piping before locat-
ing the pipe through the wall. Before securing the inside and
outside collars to the wall, use a silicone sealer between pipe and
opening to insure a water and air tight seal.
SEALWITH
RTVSEALANT _ _"
3. If the optional 2" ventpiping is to used, the 2" street elbow, Y'
to 2" reducer and Y' (minimum) section of 3" PVC, ABS or
CPVC pipe must be supplied locally.The 3" (minimum) section
of 3' PVC, ABS or CPVC p'pe must be attached to the blower
using 3 sheet metal screws.
21