Filter
Top Products
WARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unlL
Failure to do so could result in
electdcal shock or personal injury
from vacuum cleaner suddenly
starting.
CLEANING AGITATOR
To clean agitator turn vacuum cleaner
over, cut off any carpet pile and lint
entangled around agitator with a pair of
scissors in the slots provided.
Frequently check and remove hair, string
and lint build-up in the brush area. If
build-up becomes excessive, follow the
steps below.
TO REMOVE BELT
Disconnect power cord from electrical
outlet, and place on paper to protect the
floor surface. Place vacuum cleaner in
the full upright posiiton.
Turn the unit over so the agitator and
base plate are facing upward.
Lockin
Tabs
-Locking
Locate the two latches and the two lock-
ing tabs which secure the base plate.
To remove the base plate, press the two
latches inward.
Push in on the locking tabs toward the
center of the vacuum cleaner.
Rotate the base plate away from the
nozzle housing. The sides of the base
plate need to be pulled slightly out-
ward to clear the wheels.
The agitator and belt are now
exposed. Carefully remove any residue
that may exist in the belt area.
Motor
Shaft
Assembly
If the belt is still attached to the motor
shaft, there will be tension on the agitator.
If the belt is not broken, remove it from
the motor shaft before lifting the agitator.
Carefully lift the one end of the agitator
and then lift the other end.
Personal Injury Hazard
Be careful when removing the agi-
tator as the belt tension is high.
Failure to do so could result in
personal injury from the agitator
releasing quickly and snapping
awa_
17