Filter
Top Products
Electrical Shock Hazard
Unplug power cord from electrical
outlet. Do not operate the vacuum
cleaner without the primary or
exhaust filters. Be sure the filters
are properly installed to prevent
motor fadure and/or electrical shock.
PRIMARY FILTER
Check primary filter frequently and clean
when dirty.
TO REMOVE PRIMARY FILTER
Remove the dust bin and dust bin lid
assembly as outlined in the DUST BIN
CLEANING section.
While holding ClHning Cam
pdmary filter Slot
over a trash con- Filter
tainer grasp filter,
rotate and lift off.
Clean primary fil-
Locking Tab
tar by gently tap- FilterCover
pingover a trash
container.Tap on several sides to ensure
bestcleaning. Rinse with water only as
needed, do not use any detergent or soap.
Allow the filter to dry for 24 hours before
putting it back into the vacuum cleaner.
When cleaning the filter no longer restores
vacuum suction to full power you need to
replace the filter.
Note: See PARTS AND FEATURES
for the filter number.
TO REPLACE PRIMARY FILTER
With slot side on
filter towards the
filter cover slide
cleaning cam
inside opening,
rotate filter clock-
wise until slots lock
onto tabs in cover.
Cleaning Cam
Slot
Filter
Locking Tab
Filter Cover
Note: Under normal use and care, your fil-
ter can be expected to last up to 5 years.
Re-assemble dust bin lid to dust bin. Insert
into vacuum cleaner and secure with dust
bin latch.
EXHAUST FILTER
HEPA
The exhaust filter must be replaced when
dirty. It should be replaced regularly
depending on use conditions.
The filter CANNOT be washed as it will
lose its dust trapping ability.
Note: See PARTS AND FEATURES for
the filter number.
Remove filter cover by pulling out at the top
of the exhaust filter cover.
I I!
Remove the exhaust filter cartridge.
Exhaust
Filter Seal
Push only on filter cartridge frame, not on
filter material itself.The foam seal of the
filter should be placed against the vacu-
um cleaner body
Replace the exhaust filter cover by placing
bottom tabs in slots and pushing in until
cover snaps into place.
16