Filter
Top Products
KMR 1250 D User Instructions English
31
Prior to initial start-up
Unloading procedure
Do not use a forklift truck for unloading as it could
cause damage to the sweeper.
The sweeper has been lashed onto a pallet to ensure that
it can be transported safely. The procedure for unpacking
the sweeper is as follows:
1. Remove the wooden boards from the pallet and nail
them onto the end of the pallet (in front of the sweeper).
2. Detach the wires holding the sweeper in place at the
ends of the pallet.
3. Knock away the blocks used for locking the wheels and
use them for the support of the wooden planks on the left
and right.
4. Drive the sweeper off the pallet and down the ramp
made from the boards.
5. The side brush has been tied to the chassis for trans-
port. Undo the cord holding it in place.
Pushing the sweeper by hand
If you wish to move the sweeper without using its own drive:
n Open the engine cover.
n Fold the cover towards the rear; it will be held in place by
the pneumatic spring.
ç Turn the lever for allowing freewheeling to position "OFF".
n Release the handbrake.
n Push the sweeper to the required destination.
Note:
Do not push the sweeper over long distances or move it at a
speed greater than 10 km/h (e.g. when it is being towed).
After moving the machine
n Put the parking brake on.
n Set free-wheeling lever to position ”ON”.
!