Karcher KMR 1250 D Vacuum Cleaner User Manual


 
KMR 1250 D User Instructions English
45
Replacing the sealing skirts
Direction of travel
The sealing skirts fulfil an important function. They retain the
partial vacuum in the area round the brushes which is es-
sential so that the sweeper can function properly. They
ensure that sweeping can take place without clouds of dust
being formed at the same time. If the sealing skirts are
damaged or worn out, they must be replaced immediately.
n Park the sweeper and switch off the engine.
n Remove the retaining screws and detach the sealing
skirts.
n Fit new skirts, and align them as follows:
The
side skirts should be adjusted so that they clear the
ground by 1–3 mm.
The rear skirt should be adjusted so that they clear the
ground by 1–5 mm.
n The front skirt cannot be adjusted. Replace the skirt as
soon as you see signs of excessive wear.
n Tighten the retaining screws.
n Park the sweeper and switch off the engine.
n Raise the side brush.
n Remove the three hex-socket bolts (5 mm Allen key).
n Detach the side brush.
n Push the new side brush onto the drive pin.
n Refit and tighten the three hex-socket bolts.
Replacing the side brush
n Stop the machine and turn it off
n Take out the ignition key
n Undo 6 screws S on the panel
n Remove the panel 1
n Unscrew the Phillips screw between the supports of the
lamp holder on the defective headlight
n Turn the lens of the defective headlight anti-clockwise
about 1/4 of a turn 2 and take out reflector housing 3
n Replace light unit
n Insert reflector housing with new light unit in panel again
from below and secure with about 1/4 of a turn clockwi-
se. Make certain it engages properly, the label
HALOGEN on the headlight glass must be able to be read
horizontally 4
n Screw in again the screw between the supports, then
secure the panel with the 6 screws.
Replace light unit