Filter
Top Products
English User Instructions KMR 1250 D
42
Changing the engine oil
Checking tyre pressures
n Park the sweeper on a level surface.
n Check the air pressure in each tyre and correct it where
necessary.
Air pressure for front and rear tyres = 6 bar.
Checking the oil level
n Park the sweeper on a level surface.
Pull out the dipstick.
n Wipe the dipstick clean and re-insert it in the filler hole.
n Pull out the dipstick again and check the result.
The oil level should be between the MIN and MAX marks.
If the oil level is below MIN – top up with oil.
If the oil level is above MAX – drain off the surplus.
n Insert the dipstick back into the filler hole.
Filling up with oil
n Pour engine oil type SAE 15 W 40 into the hole for the
dipstick.
!
Caution! Danger to the environment from engine
oil
After carrying out an oil change, ensure that the waste oil is
passed to an appropriate collection point or official disposal
company.
!
Caution,
n Run the engine until it reaches its normal operating tem-
perature.
n Make sure the sweeper is standing on a level surface.
n Open the unit cover.
n Place a drip pan under the engine.
ç Hold the end of the drain tube over the drip pan and let
the old oil run out.
n Close off the end of the drain tube again.
n Pour engine oil into the filler hole.
Capacity = 1.1 litres
n Check the oil level with the dipstick – see “Checking the
oil level”.
n Wipe up any oil spillage and dispose of the waste oil
appropriately.
MAX
MIN