Karcher KMR 1250 D Vacuum Cleaner User Manual


 
KMR 1250 D User Instructions English
37
Typical applications
!
Caution while sweeping!
Do not sweep up packing bands, wires or similar items,
otherwise the sweeping mechanism will be damaged.
Do not sweep any burning/glowing objects.
Sweeping on dry ground
If there is a large amount of rubbish, such as several layers
of leaves
n remove the bulk by hand before you start with the
sweeper.
For a small amount of normal dirt
n
on an even surface:
lower main brush
set the lever to the middle position
(minimum
brush wear).
n
on an uneven surface:
lower main brush
set the lever to the lower position
(increased
brush wear).
n switch on dust extraction
set the switching mode lever to dry
.
n for cleaning right up to the edges – lower the side brush
.
At regular intervals:
n clean the filter,
n empty the waste hopper.
Notes: If you are sweeping up fine dust, use the side brush
as little as possible as it will increase the amount of dust
stirred up by the sweeper. If the side brush encounters an
obstacle, it automatically swivels back inside the outer
contours of the sweeper. You should nevertheless try to
avoid collisions.
While the sweeper is operating, the filter should be cleaned
approx. every 15–30 minutes (depending on amount of
dust).
Sweeping on damp or wet ground
Follow the same procedure as for sweeping on dry ground.
In order to protect the filter from moisture
n switch off the dust extraction
set the sweeping mode lever to wet
.
At regular intervals:
n empty the waste hopper.