Filter
Top Products
22
3. Burner Adjustment: The Lillehammer is
equipped with a variable gas control valve. that
provides easy adjustment of the flame height
appearance and heat output. To adjust the flame
between the HI and LOW setting, rotate the HI/
LOW knob, located in the center of the valve face.
Flame height will adjust approximately 1.0” to
1.5” between the LOW and HIGH settings. See
Figure 26.
NO SMOKE OR SOOT SHOULD BE PRESENT. CHECK
LOG PLACEMENT IF ANY SOOT OR SMOKE IS
DETECTED. IF SOOT OR SMOKE PERSIST, THE AIR
SHUTTER MAY NEED TO BE ADJUSTED.
See Air Shutter/Flame Appearance section of this
manual for proper air shutter settings and
adjustments. Note: the more offsets on the vent
system, the greater the need for an air shutter
adjustment.
The illustration above depicts the flame appear-
ance on the “high” setting after burning approxi-
mately 15 to 20 minutes.
WARNING: AIR SHUTTER ADJUST-
MENTS SHOULD ONLY BE PERFORMED
BY A QUALIFIED PROFESSIONAL SER-
VICE TECHNICIAN.
CAUTION: DO NOT ATTEMPT TO ALTER
THE FLAME APPEARANCE BY POSITION-
ING THE GAS VALVE IN ANY OTHER POSI-
TION OTHER THAN THE FULL “ON” POSI-
TION.
Operation of Appliance
1. Always follow the Safety Guidelines and Lighting
Instructions found on page 27 (inside back cover).
These instructions are also found on the metal
Rating Plate attached to the stove.
2. The Lillehammer is equipped with an On/Off/T-
stat rocker switch or can be controlled using an
optional wall mounted thermostat.
3. When lit for the first time, the Lillehammer will
emit an odor for several hours. This odor is the
burn-off by-products of internal paints and
lubricants used in the manufacturing process.
4. Condensation may occur on the glass upon each
lighting of the appliance. This “fog” will disappear as
the appliance heats up.
5. Keep the controls and the area under the appli-
ance free of debris, vacuum this area frequently.
Always keep the appliance area clear and free
from combustible materials, gasoline and other
flammable liquids.
If and when a vacuum is used for any service on
the stove, ALWAYS be sure the stove is cold and
that there are NO hot embers or sparks.
6. Remember, this appliance has a continuous
burning pilot flame. Exercise caution when using
products with combustible vapors. Always shut-
off the gas supply while servicing the stove.
7. CAUTION: DO NOT OPERATE THIS APPLIANCE
WITH THE GLASS REMOVED CRACKED OR BRO-
KEN. Replacement of the glass should be done by
a licensed or qualified service person. Use only
replacement glass provided by your authorized
Jøtul dealer. Never use any substitute materials.
8. Clean the glass only when necessary. Wipe surface
with a clean, dampened, soft cloth. Follow with a
dry, soft towel as desired. Take care not to scratch
the glass surface.
WARNING: DO NOT USE ABRASIVE
CLEANERS ON THE GLASS. NEVER
CLEAN THE GLASS WHEN IT IS HOT.
1 - 2
3 - 4
3 - 4
Figure 26. Correct flame picture.