Janome 9500 Sewing Machine User Manual


 
101
1
2
3
4
5
1
2
4
4
3
7
5
8
11
10
9
5
6
1
2
3
CARE AND MAINTENANCE
WARNING:
Turn the power switch off and unplug the machine before
cleaning.
NOTE:
Do not dismantle the machine in any way other than what
is explained on this page.
Cleaning the Hook Race and Feed Dog
Remove the Hook Cover Plate by sliding the hook cover
plate release button to the right. Take out the bobbin.
Remove dust and lint with a lint brush.
(You may also use a vacuum cleaner.)
1 Remove the Set Screw on the needle plate with the
screwdriver supplied with the machine. Remove the
Needle Plate.
2Take out the bobbin. Lift up the Bobbin Holder and
remove it.
3 Clean the Bobbin Holder with a Lint Brush.
4 Clean the Feed Dog and Hook Race with the Lint
Brush.
5 Clean the Hook Race with a dry cloth.
(You may also use a vacuum cleaner.)
1 Screwdriver
2 Setscrew
3 Needle Plate
4 Bobbin Holder
5 Lint Brush
6 Feed Dog
7 Hook Race
8 Soft Dry Cloth
Assemble the hook race
1 Insert the Bobbin Holder.
2 The Knob of the bobbin holder should fit next to the
Stopper in the hook race.
3 Reattach the needle plate, aligning the Needle Plate
Guide Pins with the Guide Holes on the needle plate
and tighten the screw.
9 Stopper
10 Knob
11 Guide Holes
NOTE:
After cleaning the machine, make sure the needle and
presser foot are attached.