Filter
Top Products
© 2001 Directed Electronics, Inc. Vista, CA 5
■ Never put the control module in the engine compartment!
■ The first step in hot-wiring a vehicle is removing the driver's side underdash panel to access the starter and ignition
wires. If the control module is placed just behind the driver's side dash it can easily be disconnected.
■ When locating the control module, try to find a secure location that will not require you to extend the harness wires
(they are 1.5 meters long). Keep it away from the heater core (or any other heat sources) and any obvious leaks.
■ The higher the control module is mounted in the vehicle, the better the transmitter range will be. If you put the control
module under a seat or inside a metal dashboard, range will suffer.
■ Some good control module locations: Above the glove box, inside the center console, above the underdash fuse box, above
the radio, etc.
Ensure that the location you pick for the switch has sufficient clearance to the rear. The switch should be well
hidden. It should be placed so passengers or stored items (such as in a glove box or center console) cannot
accidentally hit it. The switch fits in a
9
/32-inch hole.
valet/program switch
control module