Filter
Top Products
© 2001 Directed Electronics, Inc. Vista, CA 25
3 SIREN DURATION 30/60 SECONDS: In the default setting, the full triggered sequence will continue when trig-
gered for 30 seconds. This can be changed to 60 seconds in the system features learn routine.
4 DOOR TRIGGER INSTANT/DELAYED: In the instant (default) setting, if a door is opened while the security
system is armed the system will trigger immediately. In the delayed setting there is a 15 second delay before the
doors will trigger the system. This gives the user 15 seconds to disarm the system after a door is opened without
the factory transmitter.
5 DOOR TRIGGER ERROR CHIRP ON/OFF: With the door trigger error chirp programmed off, the system will not
report an invalid zone on arming when the door trigger wire is active. This eliminates the extra chirps that occur
when interfacing with vehicles that have exceptionally long dome light delay circuits.
6 SENSOR SHUNT ZONES 2 AND 4/ALL ZONES: In the default setting, all sensors with the exception of the door
zone will be bypassed when a trigger is grounded three seconds after a (+) pulse on the WHITE/BLUE (trunk is
opened). If programmed to the all zones setting, all zones including the doors will be bypassed when the trunk
is opened with the factory transmitter.
7 PANIC/AUXILIARY OUTPUT: In the default setting, pressing the transmitter lock button twice within three
seconds will trigger the panic mode, and the H1/12 wire will be set to delayed accessory output. If programmed
to the auxiliary output setting, pressing the lock button twice within three seconds will send a (-) pulse on the
RED/WHITE auxiliary output wire.
8 NO FUNCTION
9 VALET/PROGRAM SWITCH PULSE COUNT 1-5 PRESSES: The system can be programmed to count the number
presses of the Valet/program switch before disarming the security system. The factory default setting is one pulse.
The unit can be set for two to five pulses using the transmitter unlock button to select the setting.
NOTE: Ghost Switch option: For added security, the GRAY wire on the two-pin Valet/program switch
can be connected to any switch in the vehicle that provides a positive (+) momentary pulse.