Filter
Top Products
BAR/BRUSH
END SECTION
2. Pull or pry out end sections as
shown in illustration.
Note: Pulley end should be
removed by pulling straight out.
3. Pull bar/brush assemblies from
agitator slots, using pliers if
necessary.
The word “BAR” is stamped
near the slots on the agitator.
Match bar side of brush assembly
with “BAR” on the agitator shell.
Push new brushes all the way
into the slots, tapping end lightly,
if necessary.
4. Line up locator on end sections
with slot on agitator. Push end
sections into position.
Screw on end plates and tighten.
Note: If bearing should fall out of
end section during disassembly
of agitator, reassemble as
shown.
5. Replace belt, agitator and
nozzle cover as shown in “How
to replace belt.”
16