Filter
Top Products
The assembled cleaner wi+l took like this
drawing (LS modet shown),
Assemble handle
Attach upper handle
Remove clean solution tank (upper tank)
from de_;p clc-an_;r,
m
AI
A2
)/
/
Attach hose holder
Position hose holder (B) onto handle by
matching tabs on rack with op[_nings on
back of handle, Make sure holes for
bolts are aligned,
Place nuts in recessed areas on back of
handle, Hold each nut in place while
tightening each bolt securely (from the
front of the brindle) with a Phillips screw
driver,
Only two nuts are needed on this model,
The extra nut is not required but has
beelq provide_ for your convenience,
i
W+thhose hook (A1) and cord hook (A2) to
back of deep cleaner, push upper handle
down onto lower handle, Push bOllS into
ho+s on front of handle. If bolts will not
go through hole easily handleis not
pushed completely down,
When handle sections are completely
together, squeeze trigger (C) and
depress Clean Surge TM Button* (D) on
upper handle.
You will hear a "snap"when the trig-
ger rod is in place.
+some models
Replace clean solution tank (upper tank)
by positioning bottom first, Press on
tank handle to snap top of tank into
place.
4
Attach tool holder
Remove tool and taped screw from
holder.
Insert projections on holder into slots on
b_k of cleaner,
Slide rack down into place, insert screw
at (E) and tight_;n with a Phillips screw-
driver,