Filter
Top Products
Read "Before you begin cleaning"
instructions on page 9.
B_ sure to ch_-ck th(; cl_aning code_ on
your upholstery. Use your deep cleaner
only on upholstery marked "W"or
"W/S".
1, Place handle in upright position,
Agitator brushes will not rotate while
handle is in upright position.
2, FIll clean solution tank with HOOVER
Carpet/Upholstery Detergent according
to instructions for Figs, 2a-8 to 2-14.
3. Attach tool to end of hose,
Do not point tools toward people or
pets.
4. Dry hands and plug deep cleaner into
a properly grounded outlet,
5. Turn deep cleaner ON, If necessary,
refer tO "Before using tool" section to
remove air from the system,
6, Gently press the tool onto the fabric.
Headlight
replacement
Press the trigger and slowly pull the noz
zte over the f[Ibric,
7, Overlap strokes by 112 inch to help
prevent streaking,
Make additional strokos without pr_;s-%ing
the trigger to remove more moisture,
8, To clean in corners or creases, Hit the
toot one-half inch ffom the fabric and
press the solution trigger. The crevice
tool (included in some models) is very
useful for this task,
g,Vacuurn up the solutiorl with the tool
without pressing the trigger,
10, For heavily soiled areas, it may be
\
necessary to repeat the cleaning
process, Make: crisscrossing strokes to
the original pattern; overlap each pass,
Make no more than 2 passes with the
solution over any one area to prevent
over-wetting and damage to fabric.
if additional cleaning iS necessary, wait
until the upholstery is completely dry
before using the toot again,
1 I . Empty recovery tank when tile motor
sound becomes higher pitched and
there is a loss in suction (see "Automatic
shut-off", Fig. 2-6),
When finished cleaning, follow "After
cleaning" instructions on page 9 and
"After using tool" Instructions on page 12,
What to buy
The deep cleaner uses a 7 volt, wedge
base type bulb, HOOVER part no.
27313106.
Where to buy
Bulbs may be purchase.d fr-orT_ autho-
rized Hoover dealers (Depot), Hoover
Factory Service Centers, or through The
Hoover Company online at
w_w, hoover Corn
How to replace
Turn cleaner off and with dry hands,
disconnect deep cleaner from electri-
cal outlet.
1, Using a Phillips screwdriver, remove
the screw as shown and lift off lens,
2, Pul! old bulb straight out of socket.
3. Push n_'_-w bulb straight into socket until
locked into place,
Excessive force is not required.
Re.position lens and secur[_ with scrP-w.
Removable brushes
Your deep cleaner is equipped with
removable brushes for easy cleaning,
To remove brushes
Disconnect cleaner from electrical
outlet,
To prevent possible leaking, remove
cle_ln solution trunk and recovery tank,
Set tanks aside,
3ress handle release pedal to lower
handle_, Turn clean_;r over so bottom is
facing up,
Ill
Grasp inner portion of brush (A) and pull
brush assembly out slightly to reveal
I.tche_ (B),
13