Filter
Top Products
After using scrub tool
TO clean scrub pad, pull it off module,
Wash it in water with mild detergent,
Rirlse and let air dry,
Pad must b(-_ completely dry before reat-
tachilqg to module and storing on deep
cleaner,
aoplaceml_nt pads may also be pur-
chased, Ask for HOOVER part no.
40308001.
To store scub module, rernove scrub
module from tool in same manner as
removing the brush module,
Align openings on back of module with
tabs in storage area (G).
Push module into position.
After using tool
1, Follow steps a and b for "After clean-
Ing" on page 9,
2, Rinse tool and hose by filling sink
with a small amount of water, Turn
deep cleaner ON and pickup the wator
with the toot,
3. Drain hose by turning deep clea_ner
ON and holding end of hose up for sev-
eral soconds, Do not press trigger,
4. Disconnect deep cleaner from electri-
cal outlet.
5, Drain solution tube (located inside
hose) by pointing end of hose in sink
and pressing trigg_-r,
6, Proceed with steps c, d, and e, for
"After cleaning" on page g
Read "Before you begin cleaning"
instructions on page 9.
1, Place handle in upright position.
Agitator brushes will not rotate while
handle is in upright position.
2, Fill clean solution tank with HOOVER
Carp(_.t/[Jpholstery Detergent according
to instructions for Figs. 2-8 to 2-14,
3, Attach tool to end of hose,
4, Hose length n]ay require} that machine
be placed at the top of the stairs to
clean upper half of stairway and at bot-
tom of stairs to clean lower half,
To prevent machine from falling, use
extra caution when cleaning on stairs,
Do not place deep cleaner on stairs.
Do not point tools toward people or
pets,
5, Dry hands and p!ug deep cleaner into
a properly grounded outlet.
6, Turn deep cleaner ON, If necessary,
refer to "Before using tool" section to
remove air frOITl the system,
B!/ --
7, Pro-spray the carpeted stair by hold-
liqg the tool (A) or (B) about one inch
abow; the carpet and push it forward
while pressing the trigger (equals one
Wet strokr-_).
8, Position tool against the riser and slightly
press It into carpet pile. Press the trigger and
pull [he tool slowly over U_e carpet (second
wet stroke). Release trigger at end of stroke,
12
9, Lift tool, and position it against riser,
Pull tool slowly over carpet without
pressing trigger (dry stroke),
It is best to altc_rnate wet and dry strokes
as described above, End with more dry
strokes to aid in froster drying of carpet.
q0, Overlap strokes by 1t2 inch to help
prevent streaking,
To avoid saturating carpet, do not use
more than 4 wet strokes over any one
area. Always end with dry strokes.
If additional cleaning is necess_]ry, W_]lt
Until the carpet is completely dry before
using the tool again.
11. Empty recovery tank when the motor
sound becomes higher pitched and
there is a loss in _;uction (see "Automatic
shut-off", Fig, 2-6),
When finished cleaning, follow "After
cJeantiqg" instructions on page g and
"After using tool" instructions on page 12.