Filter
Top Products
Press both latches (B) and pull brush
block out, The brushes can be cleaned
under running water.
To replace brushes
Align posts (C) on both ends of brush
assembly with slots (D) in cleaner hous-
ing,
Make sure that the square post (E) also
aligns _'ith the square hole (F), Turn
brushes slightly until post fits easily into
hole,
Press brush firmly to snap into place.
Storage
aefort_" storing :
• Ei-l/pty solution tank and rqnse
thoroughly with clean water.
• Roplac@ empty so;ution tank and
turn deep cleaner ON, Squeeze
trigg_.'r and push deep clean_'r for-
ward and back several times to
exp_;I any solution remaining in the
deep cleaner's system, (Do not use
deep cleaner on wood floors,)
• Empty recovery tank and rinse
thoroughly with clean water,
Allow brushes and underside of deep
cleaner to air dry thoroughly before
storing deep cleaner on a carpeted or
wood surface.
Do not store deep cleaner with a full
solution tank in place.
I-j?_.'I[eJf_lqIL'rjB'T"d_
Lubrication
The motor is (_'quipped with boarings
which contain sufficient lubrication for
the life of the motor. The addition of
lubricant could cause damage, Do not
add lubricant to motor bearings.
If a mlllor problem occurs, it usually can
be solved quite easily when the cause is
found by using the check list bE;low,
Possible cause
Possible solution
• Not firmly plugged in
• Plug unit i;q firmly
• No voltage in wall plug
• Check fuse or breaker
• Blown fuse/tripped breaker
" Replace fuse/reset breaker
Possible cause
Possible solution
• Recovery tank full/automatic
shut off engaged
• Removo and ompty recovery tank
• Blockage in tool on end of hose
e Remove tool _nd cl_-_r blockage
- Recovery tank lid not on
correctly
• Make sure lid is on securely
• Recovery tank lid not on
correctly
• Make sure lid is firmly in place
• Pump needs to be "primed"(when
using tool)
• See "Before using tool" section, p,11
Possible cause
Possible solution
• Dirty filter screen on bottom of unit
• Cloan scr_;_.rl as sbown in Fig. 3-2
• Speed selector on OFF
• Mows, [-_p(_-[;dst;lector to Low or Hi
14
Possible cause
Possible solution
• Solution tank not firmly in place
• Make sure tank is securely locked im
position
• Solution tank empty
e Refill t_nk according to Instructions for
surface being clef]ned