Filter
Top Products
E
N
G
L
I
S
H
- 5 -
4- How to use the wireless keypad with display*
The wireless keypad with display offers a complete range of tools to manage your
alarm system, from normal operation to dedicated user functions.
The keypad is used to arm and disarm your security system using a valid access
code or key TAG. The master code or TAG is required to modify other users'
codes and TAGs.
ARMING USING YOUR CODE OR TAG
If the keypad is not in its base, please return it there (for Total or Annex set only).
Press an arming key on the keypad.
If the system diagnoses a fault on arming, a fault message is displayed. Press the
OK key or the arming key to bypass the faults and continue the arming process.
Enter a valid code or present a programmed TAG
The arming tone is emitted by the keypad and by the panel siren
(if setup).
The screen counts down the exit time remaining.
Arming is automatically completed at the end of the delay (Depends on
site configuration). The icon confirms the completion of setting.
The screen clears after a few seconds.
For total set arming, the keypad's left light indicator is on during the exit delay.
For part set arming, the keypad's right light indicator is flashing during the entire
set period.
DISARMING USING YOUR CODE OR TAG
To enable you to get to the keypad without triggering an alarm, your installer has
programmed an entry delay of 30 seconds (Depends on site configuration).
Enter a valid code or present a programmed TAG
The disarming tone is emitted by the keypad and by the panel siren
(if set up).
Disarming the system will also stop the sirens if an alarm is triggered. Stopping
the siren does not interrupt the transmission of the alarm to the ARC.
Note : Depending on the configuration of your keypad, this will disarm the total set or the
entire system. In the latter case, the annex set might need to be re-armed.
* The system may include 0 to 4 keypads of this type
Total set arming
Part set arming
TAG
4- or 6-digit code
4 or 6-digit code