Filter
Top Products
3- Understanding the system tones
SIRENS
A siren is an effective deterrent due to its power and very irritating tone.
The system has a siren built in the control panel. An optional remote
siren can be added.
In addition, the panel built-in siren emits an audible confirmation
tone when arming and disarming the security system and a fire
tone when a smoke detector is triggered. The volume levels can be
adjusted by the installer.
E
N
G
L
I
S
H
SYSTEM TONES
- 4 -
TOTAL SET
ARMING
DISARMING
PART SET
ARMING
FAULT
ALERT
ENTRY DELAY
Sequence of 3 modulated sounds
When arming total set, confirms that the
control panel has received a valid code or
TAG and is preparing to arm total set.
When Disarming, confirms that the
control panel has been successfully
disarmed.
When arming the part set, confirms that
the control panel has received a valid
code or TAG and is preparing to arm part
set.
This tone indicates a fault in the system.
Confirms the transmission of an alert to
the Alarm Receiving Centre.
After you open the entry door, the entry
time starts. You should disarm your
system within this time. Beeps sound at
the end of the entry time.
Continuous beep
Sequence of 2 modulated sounds
Duration : 2,5 seconds
2 times 7 fast beeps
4 beeps in case of alert...
Upon entry...
EXIT DELAY
Beeps sound at the end of the exit time
until the system is armed.
Upon arming...
One beep every second
Duration : 2,5 seconds
sent via the keypad
ANNEX SET
ARMING
Duration : 4 seconds
One beep per second