Filter
Top Products
N
G
L
I
S
H
- 10 -
DURESS CODE
A duress code can be used if you are forced to disarm your security system
under duress. Your duress code is +1 to your code (1234 => 1235, 6789 =>
6780).
The system will disarm as normal however a silent alert signal is transmitted to
your Alarm Receiving Centre.
INCORRECT CODE PROTECTION
If you enter 5 successive wrong codes, the keypad is blocked for 5 minutes.
PERSONAL ATTACK
You can send an instant personal attack alarm whenever you feel threatened
whilst at home, even when your system is not armed :
Press the “SOS” keys simultaneously
The siren is triggered (depending on configuration).
The Alarm Receiving Centre is alerted.
PROGRAMMING YOUR KEYPAD
The keypad can have up to 10 users. User 1 has the master code or master TAG.
To enter programming :
• Press “on” and “off” control keys simultaneously.
The red light will flash slowly.
• Enter the master code or present the master TAG.
To change or set additional user codes :
• Select and enter an existing or new single digit user ID (0-9).
• Enter the new code for this user.
A double beep on the keypad will confirm entry.
• Enter the new code again to confirm it.
A double beep on the keypad will confirm entry.
To change or set additional key tags :
• Select and enter an existing or new single digit user ID (0-9)
(User 1 is always the master).
• Present the new key TAG.
A double beep on the keypad will confirm that the new TAG is
programmed and replace the previous TAG if any.
Code + 1
+