Filter
Top Products
SECTION 5
Menu Mode Programming
••••••••••••••••••••••••••••••••••••••••••••••
Zone Programming Overview (∗
∗∗
∗56 and ∗
∗∗
∗58 Menu Modes)
Use
✱
56 Zone Programming to program zones, zone types, report codes, enroll 5800 RF Wireless
Transmitter serial numbers, and identify the type of loop input device(s). This mode can also be used
to enter alpha descriptors for programmed zones; however, we recommend entering descriptors in
menu mode
✱
82 (Alpha Descriptor Programming) after all zone programming has been completed.
✱
58 Expert Programming Mode offers a faster method of zone programming for those who have had
previous experience in programming control panels of this type.
✱56 Zone Programming Procedure
Zone Programming involves:
1. Entering the zone number to be programmed;
2. Making appropriate entries at the prompts;
3. Confirming the serial number of wireless transmitter zones.
Start Zone Programming mode by pressing
✱
56 while in Data Programming mode. The following
prompts are displayed:
PROMPT
VALID ENTRIES and EXPLANATION
SET TO CONFIRM?
0 = NO 1 = YES
If 1 (Yes) is entered, you will be prompted to confirm each transmitter after entering the
serial and loop numbers (at the “XMIT TO CONFIRM” prompt later in this procedure). We
recommend that you confirm the programming of every transmitter.
Enter Zn Num.
(00 = Quit) 10
Enter the zone number that you wish to program (e.g. zone 10 as shown in the display).
wired zones 01-06; wireless zones 09-24; button zones 49-56
Enter a report code for zone 91 to enable addressable device reporting.
Enter a report code for zone 92 to enable duress reporting.
95, 96, 99 are emergency (panic) key zones.
00 to quit; [∗] to continue
Zn ZT RC In: L
10 00 10 RF: 1
A summary display appears.
“IN: L” appears for wireless zones and indicates input type and loop.
“HW: RT” appears for hardwire zones and indicates configuration (EOL, NO, NC,) and
response time selection.
[∗] to continue
10 Zone Type
Perimeter 03
Each zone must be assigned to a zone type (list below), which defines the way in which the
system responds to faults in that zone.
Note: If 00 is entered, Delete Zone ? will be displayed.
00 = Not used 07 = 24-Hr Audible 20 = Arm–STAY*
01 = Entry/exit #1 08 = 24-Hr Aux 21 = Arm–AWAY*
02 = Entry/exit #2 09 = Fire 22 = Disarm*
03 = Perimeter 10 = Interior w/Delay
23 = No Alarm Resp
04 = Interior Follower 12 = Monitor Zone 24 = Silent Burglary
05 = Trouble Day/Alarm Night 14 = Carbon Monoxide 77 = Keyswitch
06 = 24-Hr Silent 16 = Fire w/Verify 81 = AAV Monitor Zone
*5800 button-type transmitters only 90 = Configurable
5-1