Filter
Top Products
Unsetting the System from any Set State
To unset the system (keypad)
1. Proceed to the keypad via the approved
route. A pulsed tone will indicate that the
entry timer is counting down.
2. Type in your User Code at the keypad
before the expiry of the entry time. The
tones will stop and the keypad will return to
the Day Mode display.
Galant V2
21-01-02 09:54
To unset the system (keyfob)
Press the OFF button on the keyfob. The system unsets with a double
beep.
To unset the System (keytag)
Hold card briefly in front of keypad LED’s. The system unsets with a
double beep.
Note: If no response is obtained after 3 seconds, when presenting a
card, then the card is not recognized by the system. If a triple
beep is heard after holding the card, there is a fault on the
system. Refer to keypad display for details.
Unsetting from Part or Night Set
Unsetting from Part set and Night set conditions is identical to
unsetting from a Full set.
6