Filter
Top Products
System Indications
In addition to the displays shown previously, the following fault
displays may appear on the keypad. If the fault cannot be rectified,
please contact your installer, explaining the exact detail on the display.
Keypad Display
Meaning
Tamper ZN:xx
A tamper fault has occurred on the zone shown.
Line Fail
The telephone line has a fault.
Comms Fail
The system cannot communicate with the monitoring
station via the phone line.
NO AC
The mains electrical supply has gone down.
Batt Low/Fail
The back-up battery is not serviceable.
Keypad Lockout
5 wrong codes have been entered. The keypads will
lockout for 10 minutes. Do not touch the keypad
during this time, as this extens the time.
RF Supervision
The system has lost the signal from a radio detector.
RF Low Batt
The battery on the radio detector on the zone number
shown has gone low. Contact your installer to have
this replaced.
Call Engineer
Contact your installer to have the system checked.
Fire
Fire alarm is in progress.
Panic
Panic alarm is in progress.
Assistance
The Assistance Hotkey has been pressed.
Keypad Tones
Continuous Tone on setting
Exit timer running
Dual tone – other times
Alarm/Fault Condition
Rapid Pulsing
Zone is open during exit time
Long interrupted tone
Entry timer counting down
Long Pulsed Tone
Fire Alarm
16