Filter
Top Products
Day Mode, Full Setting and Unsetting
Day mode is the normal mode for the system. In
this state the display will be similar to that
shown on the right, with the time and date.
Galant V2
21-01-02 09:54
Full Setting the System
To full set the system (keypad)
1. Type your User Code.
2. Press 1 (FULL)
A constant exit tone will sound.
Open Zn:02
Exit Now
FULL SETTING
Exit Now
The exit tone will become broken as the user
passes detectors on the exit route. The exit tone
will become constant, when the last detector on
the exit route has been passed.
Two confirmation beeps indicate that the system
has set and the screen will go Blank.
Note:
To abort the setting procedure during the
exit time, press the * key.
To full set the system (keyfob)
Press the
ON
button on the keyfob. Full setting will commence as in
point 2 for keypad setting.
Note:
To abort the setting procedure during the exit time, press the
OFF
button.
To full set the system (keytag)
Keytags can be used to full set the system and to unset from any set
state.
Hold keytag in front of LED’s for 3 seconds. Full setting will
commence as in point 2 for keypad setting.
Note:
To abort the setting procedure during the exit time, hold keytag
briefly in front of LED’s.
5