Filter
Top Products
System Overview
(cont’d)
–
6
–
Fire Protection
The fire protection portion of your security system (if used) is always on and will
sound an alarm if a fire condition is detected. Refer to the FIRE ALARM SYSTEM
section for important information concerning fire protection, smoke detectors and
planning emergency exit routes from your premises.
Burglary Protection
The burglary protection portion of your system must be turned on or "armed" before
it will sense burglary alarm conditions and sound an alarm. Your system can be
armed in one of four modes: STAY, AWAY, INSTANT and MAXIMUM. Refer to the
ARMING THE SYSTEM sections for instructions in using these modes of operation.
Your system also provides a CHIME mode for alerting you to the opening and closing
of doors and windows while the system is disarmed.
Memory of Alarm
When an alarm or trouble condition occurs, the keypad displays the number(s) of the
zone(s) that caused the problem, and displays the type of alarm or trouble (ex. FIRE,
ALARM, CHECK). The display remains until it is cleared by entering the OFF
sequence (security code + OFF key) twice.
Pager Notification
If you have chosen to be notified of alarms or other system conditions by pager, the
following codes will be sent to your pager by the control:
1811=Trouble 1911=Alarm
1001=Open 1002=Close