Filter
Top Products
– 21 –
Device Programming
This menu is used to program keypads, receivers, and relay modules, etc.
Device Address 00 is always set as an alpha keypad assigned to Partition 1 with no sounder suppression
options, and these settings cannot be changed.
From Data Field Programming mode, press [#]93 to display "ZONE PROG?" Press 0 repeatedly to display "DEVICE PROG?"
PROMPT
EXPLANATION
DEVICE PROG?
1=YES 0=NO 0
Press 1 to enter Device Programming.
DEVICE ADDRESS
01-15, 00=QUIT 01
The device address identifies the device to the control. Enter the 2-digit device address number to match
the device’s physical address setting (01-15).
NOTE: If using the 4285/4286 Voice Module, it must be used at Device Address 04.
Select the type of addressable device as follows:
0 = device not used 3 = RF receiver (5881)
1 = alpha keypad (6139/6160) 4 = output relay module (4204)
2 = fixed keypad (6137/6150) 5 = voice (VIP) Module (4285/4286)
DEVICE TYPE
0
Press [✱] to accept entry.
Alpha Keypad
PROMPT
EXPLANATION
01 CONSOLE PART.
1
If you selected device type 1 (alpha keypad) or 2 (fixed keypad), this prompt appears. Enter the addressable
device’s default partition number (1 to maximum number of partitions programmed for system in field 2*00).
This is the primary partition for the device.
Press [✱] to accept entry.
01 SOUND OPTION
00
Keypads can be individually programmed to suppress arm/disarm beeps, entry/exit beeps and chime mode
beeps. This helps prevent unwanted sounds from disturbing users in other areas of the premises.
Enter a number 00-03 for the keypad sounding suppression options desired for the keypad as follows:
00 = no suppression
01 = suppress arm/disarm & entry/exit beeps
02 = suppress chime mode beeps only
03 = suppress arm/disarm, entry/exit and chime mode beeps
Press [✱] to accept entry.
RF Expander
PROMPT
EXPLANATION
01 RF EXPANDER
HOUSE ID 00
If you selected device type 3 (RF receiver), this prompt appears. Enter the 2-digit House ID (00-31). This is
required if you are using a wireless keypad (5827/5827BD).
Press [✱] to accept entry.
VIP Module
PROMPT
EXPLANATION
01 MODULE PART.
1
If you selected device type 5 (VIP Module), this prompt appears. Enter the partition number 1-2 in which the
module is located.
Press [✱] to accept entry.
Press 00 + [✱] to exit Menu mode.
Press ✱99 to exit Program mode.