Filter
Top Products
E-8
Preparations for Operation
Setting Filter in Purifier (Perform the same procedure when replacing filter.)
Remove the panel.
Lay a soft cloth or the like beneath the purifier to protect the floor against scratch.
No cleaning effect is obtainable if the filter is installed with plastic bag. It may also be a cause of malfunction.
Do not tip over or tilt the purifier.
Disengage the tabs of the
pre-filter (4 locations).
CAUTION
Place the unit on a level, stable surface.
Hold the panel at both sides, pull it
gently forward and then slightly upward,
and remove it.
Remove the pre-filter.
Remove the filter.
(There are dust filter and deodorizing filter.)
Remove the packing.
Take the filter out of a plastic bag.
Remove the filter packed in a plastic bag from inside the unit.
Install the Deodorizing filter.
Install the deodorizing filter so that its black surface
faces the front (white surface in the back).
Insert the filter all the way until the label
(deodorizing filter position indicator) is hidden.
Note
Be sure to take out the filter from a plastic bag.
Do not block the filter front face with cloth or paper.
Same precautions should be taken for the dust
filter as well.
Install the dust filter
on the unit.
Insert the filter all the
way until the label (dust
filter position indicator) is
hidden.
Install the pre-filter on the unit.
Be sure to remove the packing.
Reinstall the panel on the unit.
Insert the two tabs on top of the
panel into the two holes on the unit.
Gently push bottom of the panel until
it clicks to close it securely.
Insert into the hole.
The back
(White)
front side(Black)
Deodorizing filter
(Black surface)
White
surface
Pre-filter tabs
Dust filter
T_S-EP-A7000.indd 8T_S-EP-A7000.indd 8 12/7/2011 2:47:52 PM12/7/2011 2:47:52 PM