Filter
Top Products
E-22
Purifier Body
(Guide for cleaning: Once a month)
Wipe off dirt on the purifi er case using a soft cloth that is moistened
with water and fully wrung. For heavy dirt, use a soft cloth moistened
with neutral detergent thinned with water. After removing dirt, use a dry
soft cloth to wipe off moisture so that no detergent will remain.
To clean the remote infrared receiver, use a thin cotton swab slightly
moistened with water to wipe off dirt. After that, use a dry cotton swab
to remove the moisture.
Remove dust on the surfaces of the panel, air inlet, odor sensor, dust
sensor section and humidity sensor using a vacuum cleaner attachment
for cleaning shelves. Then wipe off with a soft cloth.
Remote infrared
receiver
Panel
Vacuum cleaner attachment
for cleaning shelves
Humidity sensor
Remote infrared receiver
Odor sensor
Dust sensor section
Dust sensor
(Cleaning guide: every 3-6 months)
Wipe the lens with a cotton swab.
Remove the dust sensor cover.
Carry out the periodical cleaning every 3-6 months.
Otherwise poor performance of the dust sensor will result.
Soak a cotton swab with a little water
and wipe off any heavy dirt with it.
After cleaning the dust sensor,
reinstall the dust sensor cover.
Do not wipe the lens forcibly. It may cause damage.
Do not disengage and engage the tabs of the dust sensor cover forcibly.
It may cause damage.
CAUTION
Cleaning (Continued)
Lens
T_S-EP-A7000.indd 22T_S-EP-A7000.indd 22 12/7/2011 2:48:08 PM12/7/2011 2:48:08 PM