Filter
Top Products
E-11
Using Remote Controller
Selecting Operation Mode (Basics)
5 operation modes are available for your choice.
In every operation mode, the fan will not stop during operation.
(In the eco operation mode, the fan may stop.
P.E-17
)
In every operation mode, air purifying function will work.
Upon every switching of operation mode, airflow rate is set to “Auto”.
Operation Modes and Tips for Selection
Operation mode
Tips for Selection
Air Purify
(Green)
Pollen
(Green)
Strong Deodorization
(Green)
Humidify
(Orange)
Skin Moisturize
(Orange)
This is a normal operation mode.
The odor sensor and dust sensor detects the degree of air contamination, and airflow rate is switched automatically.
During auto sensor operation, airflow rate ranges from Silent to High.
This mode is recommended when you have concerns about pollen contamination.
The unit automatically operates while the odor sensor and the dust sensor sense the air contamination
level.
In the automatic operation, airflow level will be Silent to Med.
This mode is recommended when you have concerns about room odor.
The odor sensor and dust sensor detects the degree of air contamination and switches to the operation with higher airflow than Air Purify mode.
During auto sensor operation, airflow rate ranges from Low to Max.
In the first one minute, Max airflow operation is performed regardless of the level of air contamination.
Room air humidity is controlled to approx. 50%.
During auto sensor operation, airflow rate ranges from Silent to High.
Room air humidity is controlled to approx. 60%.
During automatic operation, airflow rate ranges from Silent to High.
Note
During operation, vibrations from the unit may slightly rock the water in the water tank.
Press
button.
Operation mode
switches every time
you press this button.
Selected operation mode indicator is lit.
Operation mode switches every time you press Mode button.
On
Air Purify
Pollen
Strong Deodorization
Humidify
Skin Moisturize
The factory setting is “Air Purify”.
From the second time onward, the memory function enables the operation with memorized conditions.
Stand-by Power Consumption
So long as the power plug is left inserted in AC outlet, approx. 4W power will be consumed even if the
unit is not used. (Unplug the power cord when the unit is left unused for an extended period of time.)
*
The airflow rate is set to “Auto” by switching the operation mode.
P.E-14
Installation
T_S-EP-A7000.indd 11T_S-EP-A7000.indd 11 12/7/2011 2:47:57 PM12/7/2011 2:47:57 PM