Filter
Top Products
Continuous,
and Manual
Operation
Single,
Continuous sweep is the operation mode set when the synthesizer is
Sweep
preset. It simply means that when the synthesizer is performing a
swept operation, the sweeps will continuously
sweep-retrace-sweep-
retrace until a different sweep mode is selected. To choose this sweep
mode, press
(CONT).
To change from continuous sweep to single sweep operation, press
($?@.
This causes the synthesizer to abort the sweep in progress
and switch to the single sweep mode. This initial keystroke cause’s
the synthesizer to switch sweep modes, but it does not initiate a
single sweep. A second keystroke (press
(%jGFJ
initiates a single
sweep. When the synthesizer is in single sweep operation, the
amber LED above the key lights. When the synthesizer is actually
performing a sweep in single sweep mode, the green SWEEP LED
lights.
The manual sweep mode lets you use the rotary knob to either sweep
from the start frequency to the stop frequency or to sweep power.
Refer to menu map 8, SYSTEM.
Press
(PRESET).
Press SWEEP
(j).
Select Manual
Beep.
The active entry area displays:
-->
SWEPT MANUAL: XXXXXXXXX MHz
Use the rotary knob to sweep from the start to the stop frequency.
The green SWEEP LED is off in manual sweep mode because the
sweeps are synthesized.
1-12 Getting Started Basic