Filter
Top Products
Power Sweep
in
dB/Hz,
and t is either “DB” or the ASCII LF terminator. For
example, for a slope of 1.5 dB/GHz use this procedure:
1. 1.5 dB/GHz = 1.5 dB/1,000,000,000 Hz
2. 1.5
dB/lES
Hz = 1.5E-9
dB/Hz
3. The programming code is “SL11.5E-9 DB”
See
Also
CPOWER
LEVEL), Power Sweep
“Power Sweep and Power Slope Operation” in Chapter 1.
Power Sweep
Function Group
Menu Map
Description
Programming Codes
See Also
POWER
This
softkey
enables the power sweep function. RF output power
can be swept both positively and negatively over a selected range.
The level of the power sweep starting point is the power level
programmed. Power sweep widths can be 45 dB wide in either
direction. However, the
settable
power sweep range is dependent on
the ALC level set. An asterisk next to the key label indicates that
this feature is active.
SCPI:
POWer:MODE
SWEeplFIXed
POWer:STARt
<num>[level
suffix]]MAXimum]MINimum
POWer:SPAN <num>[level suffix]]MAXimum]MINimum
Analyzer:
PSl
function on, PSO function off.
POWER LEVEL ,
Power
Slope
“Power Sweep and Power Slope Operation” in Chapter 1.
HP 8360
User’s Handbook
Operating and Programming Reference
P-7