Filter
Top Products
Heat & Glo • Multi-Sided Woodburning Fireplace • 34977 Rev T • 11/07
20
6 Tabs bent
in 90°
Tabs bent in to
rest against pipe
Attic Insulation Shield
Ceiling Firestop
13 in.
(330 mm)
17 in. (432 mm)
diameter
Insulation
Insulation
Pipe
Pipe
Figure 5.7 Install Attic Insulation Shield Above the Ceiling
6 Tabs bent
in 90°
Tabs bent in to
rest against pipe
Attic Insulation Shield
Ceiling Firestop
13 in.
(330 mm)
17 in. (432 mm)
diameter
InsulationInsulation
Pipe
Pipe
Figure 5.8 Install Attic Insulation Shield Below the Ceiling
Fire Risk
• DO NOT pack insulation or other
combustibles: between ceiling fi restops;
between chimney and attic insulation
shield.
• ALWAYS maintain specifi ed clearances
around chimney and ceiling firestop
systems.
• Install ceiling fi restops as specifi ed.
Failure to keep insulation or other material
away from chimney pipe may cause fi re.
WARNING
An insulation shield must be installed when there is a pos-
sibility of insulation coming into contact with the factory built
chimney system. Installation of a ceiling fi restop is required
(see Figures 5.7 and 5.8).
• Roll the shield (around the chimney if already installed)
until you have a 3 in. (76 mm) overlap and the three holes
on each side match up (large holes on top).
• Insert three screws into the matching holes to form a
tube.
• Bend three tabs on the bottom of the tube inward to 90°
to maintain chimney clearance. See Figure 5.6.
• Rest the insulation shield on the ceiling fi restop below.
• Bend the three short tabs at the top of the shield inward
to 90° to maintain the 2 in. (51 mm) clearance from the
chimney.
• Bend the remaining top tabs to just meet the pipe.
3 in. (76 mm)
overlap
Insert three
screws
Bend inward
90°
Bend remaining tabs
to rest against pipe to
prevent insulation
from falling in.
E. Install the Attic Insulation Shield
If you wish to make a custom shield or barrier, follow these
guidelines:
• Metal is preferred, although any material stiff enough to
hold up against the insulation can be used.
• The shield or barrier must be tall enough to extend above
the insulation and prevent blown-in insulation from spilling
into the cavity.
• Maintain specifi ed cleaances around chimney.
• Check instructions and local codes for further details.
Figure 5.6 Prepare Attic Insulation Shield
¨
¨
¨