Filter
Top Products
13
Additional lateral
support for chimney
above roof (or enclosed
in chase) if needed
(Section 8)
Ceiling firestop
on floor of attic
(Section 8)
Support straps
on rafter supports
chimney (not shown)
(Section 8)
Termination cap
(Sections 8)
Chimney penetrates roof
preferably without affecting
roof rafters (Section 8)
Framing headed off
in ceiling joists (Section 8)
Enclosed space above
and around fireplace (Section 6)
Mantel and surround (Section 12)
Decorative facing
and trim (Sections 12)
Hearth extension
(Sections 12)
Factory-built fireplace
Protective metal
hearth strip(s) (Section 7)
Combustible
framing/header
on top of
V-shaped
standoffs
(spacers)
(Section 6)
Chimney system
(Section 8)
Attic insulation shield must be used
here to keep insulation away
from chimney if attic is insulated
(Section 8)
Attic Shield Collar
(Section 8)
Storm Collar
(Section 8)
Outside Air
(both sides)
Chase Top Flashing
(Section 9)
(4) Roof Radiation Shields
(Section 8)
5
5
Getting Started
A. Typical Fireplace System
Figure 5.1 Typical Fireplace System
Installer Guide
Heat & Glo • RUTHERFORD-50 • 4059-333 Rev C • 06/08