Filter
Top Products
37
Heat & Glo • SOHO-N-AUB • 2197-980 Rev. F • 5/12
Figure 9.2 Fixed Glass Assembly
GLASS
ASSEMBLY
LATCHES
(BOTH BOTTOM
AND TOP)
GLASS
ASSEMBLY TAB
GLASS
CLIP POST
B. Covers Removal For Servicing
Control Compartment Access Door
• Lift the lower door up and out to access the gas controls.
Trim Door and Glass Door
• Lift the front trim door up and out away from the appliance
side surrounds. Replace the door when servicing is
complete.
• Noting carefully how the brackets t on the glass, release
the two spring latches at the top and two at the bottom
of the glass door. Carefully lift the glass up and out away
from the appliance. See Figure 9.2.
NOTICE: All screws which were removed must be replaced.
Pilot Assembly/Ignition System
• Remove the log set and burner assembly.
• Disconnect the gas supply tube from the outlet side of
valve.
• Disconnect the orange ignitor wire (I) and white sensor
wire (S) from module.
• Unscrew the pilot assembly bracket and remove, the
pilot assembly along with silicone sealant grommet.
D. Parts Replacement
Fan
• Unplug the fan from the AUX300CE and slide the fan out
the front of the lower controls compartment.
• Fan can be operated at 3 speed levels using RC300AU
remote and AUX300CE. Refer to RC300AU section.
• The fan will automatically turn on after 3 minutes and will
stop 12 minutes after unit has been turned off.
Glass Panel
• To replace the glass door, place the bottom edge into
the lower holders, push glass against unit and secure
the two spring latches at the top and bottom.
E. Adjustments And Replacement Parts
Adjustments and replacement parts for this appliance
should only be done by a qualied service person. A wir-
ing diagram for the appliance is shown in Section 12. A
service parts list is shown in Section 16 of this manual.
F. Install Trim and/or Surround
• Install optional trim kits and/or surrounds using the
instructions included with the accessory.
• Use non-combustible materials to cover the gap between
the sheet rock and the appliance (when applicable to the
model).
G. Air Shutter Setting
Figure 9.3
C. Components Removal For Service
• Carefully lift up and remove the logs.
• Remove the base pan.
• Unscrew the brackets at both ends of the burner and the
top two screws locating the pilot bracket (see Figure 9.3).
Slide the burner away from the burner orice.
Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Removing Fixed Glass Assembly
• Pull the two bottom glass assembly latches off of the tabs
on the glass assembly. Tip bottom of glass assembly out
to remove from the appliance (see Figure 9.2).
Replacing Fixed Glass Assembly
• Replace the glass door by sliding top tabs on the glass
assembly under the glass clips. Position the glass down
onto the bottom glass clips making sure that the glass
clears the glass clip posts. Latch bottom glass clips once
glass door has been properly placed on appliance.
Natural Gas Propane Butane
SOHO-N-AUB
7/16 in
(1.1 mm)
N/A N/A
LOWER PILOT
BRACKET SCREWS
PILOT BRACKET
RETAINING SCREWS
BURNER RETAINING SCREWS